Doepfer

Doepfer A-160-2 Clock Divider II

--

$125.00

In Stock
Module A-160-2 is an enhanced version of the standard clock divider A-160. The module is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly for rhythm uses. The Clock input will take any digital signal from, eg., an LFO, MIDI sync, or the gate from a MIDI-CV interface. At the outputs, you have access to three sets of seven different sub-divided clock signals, from half the clock frequency down to 1/128. The low/high levels of the output signals are 0V and about +10V. The A-160-2 also has a reset input. Whenever a reset signal is sensed, all outputs are set to certain levels which depend upon the selected mode.

Module A-160-2 is an enhanced version of the standard clock divider A-160. The module is a frequency divider for clock/trigger/gate signals, designed to be a source of lower frequencies, particularly...

« less

more »

Width: 4HP
Max Depth: 35mm
Power: 50mA@ +12V , 50mA@ -12V , ?mA@ +5V

Features

  • Three different sets of dividing factors, selected by a three-position switch at the front panel:
    • Power of two: 2, 4, 8, 16, 32, 64, 128
    • Prime numbers: 2, 3, 5, 7, 11, 13, 17
    • Integer: 2, 3, 4, 5, 6, 7, 8
  • Two output modes, selected by a two-position switch at the front panel:
    • Gate mode: outputs act like the outputs of typical binary dividers
    • Trigger mode: in this mode the outputs are AND-wired with the clock signal (i.e. the clock pulsewidth affects the pulsewidth of the outputs)
  • Clock edge type selected by a jumper on the pc board:
    • Positive: the rising edge of the clock signal triggers the state change of the outputs
    • Negative: the falling edge of the clock signal triggers the state change of the outputs
  • Reset behavior by two jumpers on the pc board:
    • Level triggered: the level at the Reset input triggers the Reset
    • Edge triggered: the edge of the signal at the Reset input triggers the Reset
    • Positive: a high level (> 2.5V) or the rising edge at the Reset input triggers the Reset
    • Negative: a low level (< 1 V) or the falling edge at the Reset input triggers the Reset
  • Output polarity selected by a jumper on the pc board:
    • Positive: non-inverted outputs
    • Negative: all seven outputs are inverted